Main / Uncategorized / Iso 2409

Iso 2409 download

Iso 2409

This fourth edition cancels and replaces the third edition (ISO ), which has been technically revised. The main changes are as follows: a) the description of suitable methods for removal of loose paint have been transferred to an informative annex as examples and, for the method using adhesive tape, the adhesive. ISO Preview. Paints and varnishes -- Cross-cut test. This standard was last reviewed and confirmed in Therefore this version remains current. General information. Current status: Published. Publication date: Edition: 4. Number of pages: Technical Committee.: ISO/TC 35/SC 9. General test. ISO describes a test method for assessing the resistance of paint coatings to separation from substrates when a right-angle lattice pattern is cut into the coating, penetrating through to the substrate. The property measured by this empirical test procedure depends, among other factors, on the adhesion of the.

15 May This British Standard was published by BSI. It is the UK implementation of. EN ISO It supersedes BS EN ISO which is withdrawn. The UK participation in its preparation was entrusted to Technical Committee. STI/10, Test methods for paints. A list of organizations represented on this. ISO Paints and varnishes — Cross-cut test. Peintures et vernis — Essai de quadrillage. STANDARD. ISO. Fourth edition. Reference number. ISO (E). Provläsningsexemplar / Preview. This European Standard was approved by CEN on CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references.

EN-ISO , ASTM D 4 WHAT'S IN THE BOX? Each TQC Cross Cut Adhesion Test Basic Cutter contains a grip with cutter. Spare parts. The following parts can be ordered separately: SP Adhesion tape, single roll, adhesion to steel N/cm. SP Adhesion tape, set of 3 rolls, adhesion to steel N/cm. The TQC Cross Cut Adhesion Test KIT CC is used to test the adhesion of dry coats of paint on their substrate by means of a series of cuts through the coating. Two series of parallel cuts cross angled to each other to obtain a pattern of 25 or similar squares. The ruled area is evaluated by using a table chart after a. Company Information. About Elcometer USA · Hours of Operation · ISO Certifications · Repair & Re-Calibration · Twitter Bird - Link to Twitter Account · Facebook Logo - Link to Facebook page.


© 2018 - all rights reserved!